So the only thing you need to bring is your playing.
HariyamaLab makes bass effects for Anagram. Founded by a bass player who brings hardware verification techniques from another field. Hardware is measured on a calibrated rig before it is modelled.
Dinah
Dinah is a mono compressor with two controls, Sensitivity and Output. It uses an OTA-style gain cell in a feedback loop. Attack, release and knee are fixed internally and are not exposed as parameters.
Sensitivity sets how hard the compressor works. One control moves several things at once. It changes the threshold, the gain at low levels, and the timing. At low settings the compressor lets go slowly, at high settings several times faster.
Output sets the level after the compressor. It sits outside the detector loop, so it does not change the amount of compression.
At high Sensitivity settings the block works as a limiter. The ratio is very high and the output level barely moves. At low settings it just takes the tops off the peaks.
Features
- Feedback design. The detector listens after the gain cell, not before it.
- This is not a clean compressor. The OTA-style gain cell adds a little colour as it works.
- Levels are referenced to the Anagram's input, so the knee sits at a normal playing level with no setup.
Uses
- Levelling a bass DI before an amp or cabinet block
- Sustain for lead lines
- Compression with fixed attack and release
CPU
Measured on the device as the difference the block adds to the host load. Mono, one instance, about 1.8 points against a chain with no blocks. In a stereo chain the host loads the block twice. No xruns in either case.
